| Trolling Motor Recommendations|
Moderators: CFFModeratorsJump to page : 1
Now viewing page 1
|Previous :: Next|
|Fishing Sonar, GPS and Marine Electronics||Message format|
|I am in the market for an I-pilot equipped MK trolling motor. My biggest concern is "extras" that may be needed to mount my mega si transducer and 360. I currently have an old MG with the HB TM transducer mount and the TSS collar to mount the 360 with the fortrex/maxxium mount. |
So my first inclination was to go with the terrova with i-pilot link. After reading up, it seemed necessary to get an aftermarket solution for both the transducer wiring and mounting the 360. This would negate any cost savings over the ultrex. Does the ultrex require the same? I know I will have to get a new mount for the 360, but anything else? Any input would be greatly appreciated.
Location: Ooltewah Tn.
|You should call Johnny at DJ Marine Electronics |
423-290-5472. He will help you.
God is Good all the time, right on time, just in time,WHY, because that's His nature.
Location: Ringgold GA
|No, Ultrex is set up for 360 and exterior transducer cables are run without problems if done correctly. They also have an ultrex now with built in Mega DI.|
Selling Minn Kota, Motorguide, Lowrance, Humminbird, Hydrowave, boating and fishing accessories plus much more...... DJS MARINE ELECTRONICS where quality and customer satisfaction are #1 CFF SPONSOR
Location: Harrison, TN
|sounds like the new ultrex with the built in mega di transducer is for you. |
i have a source for an adapter to mount the 360 to the ultrex........MUCH more cost effective than the one i bought from hb
Edited by FishingwithRusty 12/4/2018 10:52 AM
There is NO substitute for time on the water!! True South Custom Lures "Fish with Confidence!" Piscifun "Go with Family" Taipan Rods
Spread the word
|Jump to page : 1 |
Now viewing page 1
|Search this forum|
Printer friendly version
E-mail a link to this thread